iPhone 6 Plus Update System reported an error of 4014. It was found that it was caused by PCB circuit defect, and the fault was repaired after Jump wire.
After the iPhone 6 Plus fell down, the WiFi of the mobile phone couldn't be turned on_The RF end Jump wire can be repaired to the test point.
iPhone 6 Plus WiFi signal is not good. After testing, it is found that the WiFi ANT filter is damaged. Change the line to give the WiFi chip an ANT, and fix the fault.
iPhone 6 Plus cell phone touch failure, using SMD REWORK STATION to blow for too long, resulting in the sealing glue Inductor Capacitor Inveracious Soldering on the back.
iPhone 6 Plus mobile phone screen has a line, and Reballing BCM5976C1 chip fault repair.
iPhone6 Plus phone card white apple, fault repair after replacing USB chip and battery.
The iPhone 6 plus cannot be charged, and the brush machine reports an error-1. Replace the baseband power supply and charging IC, and short circuit the 2-pin and 3-pin of q1701. The fault is perfectly repaired.
iPhone 6 plus cannot be turned on. It is found that the phone cannot be turned on due to WiFi damage.
iPhone 6 Plus was started and Stuck on Apple logo was restarted. After detection, it was found that U5411_RF was damaged, and the fault was repaired after replacement.
